![]() In this instance, they will need to be cleaned out with a tap water conditioner as well as hot water. ![]() Small, cylindrical capsule (film canister, empty fish food container, or a prescription container)Įnsure you do not use any chemicals or soap.įilm canisters can sometimes contain traces of heavy metals.Make sure you place the output tube so the water comes out close to the surface. Now you can place your new filter into the tank. Then cut some airline tubing and plug it into the air pump (outtake valve).Īround 3-4 inches of airline tubing will work best.Ĭlean water will flow from this tube back into the tank. This means all the dirt and mess in the tank will get caught in the sponge. Attach The Plastic Tube To Your Power Head’s Intake Valveįrom here, the power head can suck up the water, allowing it to go through the sponge. Once this is complete, push the tube to the bottom of the sponge, so that the sponge covers all of the holes. You can use your finger to poke the hole. Then poke a hole in the sponge, and slide the tube in. To do this, you can use styrofoam or a PVC end cap, provided it fits the tube. Plug The TubeĮven though the tube is going into the sponge, the bottom needs to be plugged up. You will need to make 8-10 holes per one inch of the plastic tube. You can choose between an electric drill or a heated nail and hammer to make the holes. Once you have done this, mark the height on the plastic tube.īelow the mark, make some air holes in the tube. You can find them at the majority of pet stores. The ideal sponge has large pores which houses good bacteria effectively. Make sure you are using an aquarium filter sponge that is wider than the plastic tube. Ideally, the tube should be twice the height of the sponge. Put The Plastic Tube On The Power Head’s Intake Valve Power head (ideally one that can pump twice as much water per hour as the water in the tank).Sponge filters are better for delicate tanks. Make sure the airline tube is pointed towards the water’s surface. This is what the clean water will come out of. Take 3 inches of airline tubing and fit it onto the output nozzle of the power head. The filter materials inside the bottle will clear the dirt. ![]() This will get rid of all the dirty water by sucking it into the bottle. Take the power heads’ intake valve and place it into the mouth of the bottle. Place The Power Head Intake Valve Into The Bottle Secure it with string, or something similar. Make sure the mesh is fine, and then wrap it over the hole. Namely, small fish, delicate fish, or shrimp. This is only necessary if you have specific types of fish. Wrap The Bottom Of Your Filter In Mesh Material Remember to pack it together well, so it can filter out big pieces of detritus. ![]() This will help to remove bacteria and toxins. You can use activated charcoal or any filter material you’d like. Put the floss into the bottle so it is dense, and it should catch the debris. You can buy filter floss at the majority of pet stores. This is so the filter material also stays in place. Pick a bottom corner to cut, leaving the base in place. You’ll want to cut two-thirds of the bottom of the bottle. The bottle’s neck should fit over the intake valve on the powerhead. The powerhead you choose to use should pump double the water into your fish tank per hour. These are most suitable for larger tanks. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |